The installation difference between slider coupling and plum coupling

时间:2014-03-17 18:55 作者:admin 点击:
The slider coupling ensures that the relative displacement of the two shafts is within the rated allowable value of the coupling.Install the two shaft sleeves on the shaft so that the tenon faces are facing each other.Rotate the two shaft sleeves so that the driving tenon with the tenon surface is at a 90 degree angle, align the groove of the central sliding block with one of the tenons, and insert the central sliding block into the tenon by hand.Put the axial limit washer.Put it into the bottom of the groove of the center slider.Tighten the screws according to the in-position torque to completely fix the two shaft sleeves on the shaft.Take out the gasket to ensure a certain gap between the two shaft sleeves and the center slider to balance the relative axial displacement.
The Torx coupling ensures that the relative displacement of the two shafts is within the rated allowable range of the coupling. Install the two shaft sleeves on the shaft so that the tenon faces are opposite. Use a wrench to fully tighten the screws on one shaft sleeve to the recommended level. Torque to insert the quincunx spacer into the fixed bushing so that the prongs can touch the bottom of the groove of the shaft sleeve, and insert the second shaft sleeve on the quincunx spacer to ensure that the prongs can contact the groove of the sleeve. At the bottom, a certain amount of force is required to complete the insertion. This is normal.Ensure the distance between the two shaft sleeves so that the metal of the two shaft sleeves will not directly contact.Fully tighten the screw to its in-place torque to completely fix the second bushing on the shaft.
You may be right | Plum-shaped elastic coupling | Elastic sleeve pin coupling | Interested in other products