one.A connecting link of an O-ring Chain for common application is pre-coated with grease in the pins. Prior to connection, confirm the grease over the surfaces of pins, and should the amount of grease is smaller, apply grease with bare hands. (If gloves are made use of, the grease are going to be absorbed by the gloves.)
Example: When the connecting link (I) of an O-ring chain for basic application is
shipped, O-rings are fitted with the roots with the pins. In case the O-rings come loose because of vibration throughout transport, refit the O-rings in on the roots of the pins.
In this case, be sure you return the grease collected in the roots of the pins towards the central surfaces of your pins, extra at portion A than at portions B shown while in the over illustration. (Portions A is worn due to sliding with all the bushings.)
2.The chain is often most easily linked on the teeth of a sprocket. Engage the links at each ends from the chain with all the sprocket teeth and fit connecting pins. In case the sprocket is often moved, the chain may also be linked around the loosened side.
3. Connecting process
one.Verify that O-rings are attached to the roots with the pins.
two.In the event the level of grease utilized on the connecting pins is compact, coat the pins with grease in the central portions.
3.Insert the connecting pins in to the bushings in the inner hyperlinks at both ends.
4.Confirm the grease is applied towards the complete face in the O-ring, and fit the O-ring onto the connecting pins.
five.Insert the connecting pins into the connecting plate and though pressing the connecting plate, set up the spring clip. Confirm whether or not the head (the finish without a split) from the spring clip is turned while in the feeding course in the chain. (See the following illustration.)
6.Make sure to verify the spring clip is securely fitted in the clip grooves on the connecting pins.
This completes jointing of the connecting hyperlink. Note that grease on the surfaces of connecting pins and O-rings could be eliminated in the course of installation function. In this instance, re-grease employing the grease on the surface with the base chain or even the grease in the polyethylene bag through which the connecting link was contained.