Tag tabHome > TAG tag > Star Flexible Coupling

　　The main design steps of the brake are as follows: 1) Calculate the load torque on the brake shaft according to the mechanical operation, and consider a certain safety reserve (multiplied by the safety factor) to calculate the braking torque.The recommended value of braking safety factor is shown in the table. ...

　　There are three types of coupling shaft deviations. The first type: radial deviation, that is, the two shafts are parallel but the center line is no longer on the same straight line. The deviation generated at this time is called radial deviation; the second type is angular deviation, That is, the deviation caused by the center of the two shafts at an angle to each other; the third type is the axial...

　　KL type slider coupling is a kind of slider coupling. The structure is similar to the cross slider coupling. The difference is that the middle block is a nylon block. The middle block is used on both sides of the half coupling end surface Sliding in the corresponding radial groove to realize the coupling of the two halves of the coupling. ...

　　Diaphragm is divided into: continuous polygonal ring shape, circular ring shape, separated connecting rod shape, spoke shape, formed diaphragm, and waved diaphragm.The characteristics of continuous polygonal ring and circular ring: each coupling is composed of several diaphragms of equal thickness.

　　Correctly install the diaphragm coupling bolt method: Insert the bolt from the outside of the small hole of the flange, and then penetrate into the diaphragm hole (pay attention to the direction of the diaphragm, the diaphragm is composed of many single sheets, rivets and rivet washers, rivets The gasket should be in contact with the buffer sleeve, otherwise it will affect...

　　The mechanical transmission mechanism can change the mode, direction or speed of the movement provided by the power, and it can be used purposefully by people.There are many types of transmission mechanisms in ancient China, and they are widely used. In addition to the above, such as seismographs, blowers, etc...

　　In the structure design and series design of the Oldham coupling, the shaft hole range (maximum and minimum shaft hole) of the coupling of each specification is determined based on the size of the transmitted torque, the structure of the coupling and the strength of the hub. Permissible use of long cross slider coupling with shaft hole...

　　Every April XNUMXst is a traditional folk festival in the West-April Fool's Day, also known as April Fool's Day.There are different opinions on its origin: one view believes that this custom originated from India’s "Festival of Interpretation".This section stipulates that every year on March XNUMX...

　　The elastic pin gear coupling is a pin made of a number of non-metallic materials, which is placed in the mating hole between the two halves of the coupling and the inner surface of the outer ring, and the two halves are connected through the pin to transmit torque. Shaft coupling, elastic pin gear coupling has a certain compensation for two shafts...

　　1) The maximum operating compensation amount refers to the two-axis phase offset formed by comprehensive factors such as manufacturing errors, installation errors, and changes in working load caused by vibration, shock, and temperature changes in the working state. ...