1. The allowable speed refers to the allowable speed within 1° of angular compensation.
2、 LD1-LD6多角橡胶弹性件为六角形，LD7-LD11多角橡胶弹性件为八角形。
3. There are Y-J1, Y-Z1, J1-Z1, YY, J1-J1 combinations of shaft holes.
4. The instantaneous impact torque is not more than 2~3 times the nominal torque.
5. The relative offset of the two connected shafts during use should not be greater than the values listed in the table below.
model
Project |
LD1 |
LD2 |
LD3 |
LD4 |
LD5 |
LD6 |
LD7 |
LD8 |
LD9 |
LD10 |
LD11 |
|
Radial△Y/mm |
1 |
1 |
1 |
1.5 |
1.5 |
1.5 |
2 |
2 |
2 |
2 |
2 |
|
Axial△Y/mm |
± 2 |
± 2.5 |
± 3 |
± 3.5 |
± 4 |
± 4 |
± 4 |
± 4.5 |
± 4.5 |
± 5 |
± 5 |
|
Axial △a/(°) |
|
|
|
|
|
|
|
|
|
|
|
Note: The above content is for reference only. The value in the table refers to the range used when the speed is less than 70% of the allowable speed.