Drum gear couplings have Type I and Type II, which are suitable for low-speed and heavy-duty conditions, such as metallurgy, mining, lifting and transportation industries, and also suitable for shaft transmission of various machinery such as petroleum, chemical, general machinery, etc. . ...
Elastic column pin coupling is used to connect the elastic column pin coupling of the master-slave shafting of power machinery.The spiral ring-shaped elastic body of the elastic column tip coupling formed by the multi-strand steel wire hinged wire fixed by the metal splint constitutes the annular free deformation space between the master and slave hubs of the coupling, and the connection...
The conditions to be considered before the universal coupling selection are as follows: 1. Whether there is a transmission device between the prime mover and the universal coupling.If there is a transmission ratio, it will be output by several shafts after passing through the intermediate transmission device, that is, whether there is power split.Considering the class of prime mover...
The radial movement of the star-shaped elastic coupling due to the centrifugal force during high-speed operation will accelerate its wear, and a shell is added.In addition to preventing dust and oil storage, insufficient thinning may cause interference. Excessive thinning will weaken the strength of the tooth, and the backlash will be very...
Universal couplings have a variety of structural types, such as: cross shaft type, ball cage type, ball fork type, bump type, ball pin type, ball hinge type, ball hinge plunger type, three pin type, three fork rod type , Three ball pin type, hinge type, etc., the most commonly used is the cross shaft type, followed by the ball cage...
The maximum allowable axis error of the two shafts of the plum blossom flexible coupling shall not be greater than the provisions of Table 5-107.The maximum amount of operating compensation refers to: vibration, shock, deformation, temperature change caused by manufacturing errors, installation errors, and changes in working load that are allowed in the working state...