时间：2014-03-09 20:09　作者：admin　点击： 次

(1) Membrane stress generated by the torque of the diaphragm coupling.Suppose the transmitted torque is T(Nm), and the total number of pieces is m. For 8-hole bolts, it is known from simplified conditions: the torque of a single diaphragm is T1=T/m, and the force on each main bolt is F =T/4mR.
(2) Bending stress caused by angular installation error.Due to the actual installation error in the axial angular direction, the diaphragm is periodically bent and deformed along the axial direction, and it is the main reason that determines the fatigue life of the coupling diaphragm.Calculate the displacement of the middle bolt hole in the axial direction caused by the angular deviation. The radial displacement and the axial displacement are fixed.The magnitude of the restoring moment H can be obtained by the angle tilt. Generally, the angular displacement of the coupling diaphragm is very small, so the diaphragm deformation is a small deformation, which can be analyzed by the small deflection bending theory of the thin plate.
(3) Due to the error of the axial installation, the diaphragm is bent and deformed along the axial direction.The displacement is loaded in the axial direction of the middle bolt hole, and the radial displacement and the axial displacement are fixed.The two middle holes at both ends are used for restraint, and the middle hole is used for bearing the load.In this way, treat it as a statically determinate simply supported mechanism.
(4) Centrifugal stress due to inertia during high-speed rotation.Assuming that the bolt and the coupling diaphragm are of the same material, the respective masses can be calculated. According to the position and the spiral angle, the centrifugal force can be calculated and acted on the total center of mass.The centrifugal inertia force of high-speed machinery is very important in the stress calculation of the structure. The centrifugal inertia force can be loaded according to the radial force F=(2∏n/60)2rp, the direction is radially outward, and the diameter of the middle bolt hole is fixed. There is no other load around the displacement, circumferential displacement and axial displacement.