cross
Slider couplingIt is composed of two halves, which are connected to the active shaft and the passive shaft respectively. It is a rigid connector, which is mainly used as a connector on some large-scale mechanical equipment.
The coupling has high torque and is flexible to use.Maintenance and repair-free.The later use and replacement are very simple. In the process of use, the noise pollution is small and the sealing performance is very good.
When using, it mainly uses concave and convex contact sliding. When the equipment is used, the displacement between the shafts can be compensated to the greatest extent. During use, the half coupling and the intermediate disk form a module and rotate at the same time, so relativity cannot occur. Mobile.
When working with relative displacement between the two shafts, the middle disk will generate a large centrifugal force, which will increase the dynamic load and wear. Therefore, please pay attention to the working speed not greater than the specified value when selecting.