时间：2015-04-27 18:18　作者：admin　点击： 次

XNUMX. Gravity lubrication.The lubricating oil is injected from the nozzle, flows through the gear backlash, and flows out from the small hole of the sleeve. This lubrication method mainly plays a cooling role, and it is difficult to form an oil film. The tooth surface wears faster than the following strong lubrication.
XNUMX. Powerful lubrication.The lubricating oil is sprayed into the small holes at the bottom of the gear teeth, and the oil enters the meshing surface under the action of centrifugal force to play the role of lubrication and cooling.The oil flows out from both sides of the tooth after passing through the meshing surface.With this type of lubrication, the oil circulates continuously, impurities flow out, and the injected lubricating oil causes a certain pressure to enter the gear tooth meshing surface under the action of centrifugal force, so it has a better lubrication and cooling effect and is suitable for high-speed and heavy-duty occasion.
XNUMX. Oil storage lubrication.The lubricating oil is injected from the nozzle, and a certain lubricating oil layer is maintained on the outer circle of the gear due to the centrifugal force of the lubricating oil during rotation.This kind of lubrication will leave the magazine in the ring gear, and the heat dissipation effect of the oil flow is also poor, so it is only suitable for occasions with low power and low speed.There is also a non-flowing oil storage lubrication method belonging to this type, which is to pour grease into the inside and seal it, and wash it regularly.