The coupling is generally composed of two half-couplings, which are used as a set. One half-coupling is connected to the output end and the other half-coupling is connected to the input end. ...
KL type slider coupling is a kind of slider coupling. The structure is similar to the cross slider coupling. The difference is that the middle block is a nylon block. The middle block is used on both sides of the half coupling end surface Sliding in the corresponding radial groove to realize the coupling of the two halves of the coupling. ...
Drum-shaped gear coupling is a key equipment for energy saving.Sometimes there are some failures, as follows: 1. Insufficient lubrication or dry grinding; 2. The oil is not clean; 3. The center deviation of the drum gear coupling is too large, and the relative displacement of the tooth surface is large;...
In the coupling, under the condition of angular displacement, the edge of the straight tooth is squeezed, and the stress is concentrated. The drum-shaped tooth surface improves the contact conditions of the inner and outer teeth, thereby reducing the friction and wear of the tooth surface and reducing the noise.Under the same conditions, the outer diameter of the inner gear sleeve and the coupling...
XNUMX. Gravity lubrication.The lubricating oil is injected from the nozzle, flows through the gear backlash, and flows out from the small hole of the sleeve. This lubrication method mainly plays a cooling role and is more difficult to form an oil film. The tooth surface wears faster than the following strong lubrication. ...
The characteristics of the roller chain coupling are simple structure (composed of four pieces), convenient assembly and disassembly, no need to move the connected two shafts during disassembly, compact size, light weight, certain compensation capability, and low requirements for installation accuracy , Reliable work, long life, successful...